Anchor: #i1004940

Section 6: Inverted-T Cap Details

Anchor: #i1004945

Plan View Example

The plan view checklist, presented in Section 3, should be followed to ensure that the details are accurate and complete. Note that, excepting dowels D, reinforcing will normally not be shown on the plan view.

Plan View Example. . (click in image to see full-size image) Anchor: #i1000481grtop

Figure 4-7. Plan View Example. .

Online users can click 4-7 to view this illustration in PDF

Cap lengths, drilled shaft spacing and beam spacing are measured along the centerline of cap.

Interior bent plan view is normally shown as above, facing the direction of increasing stations. Ends of the cap may be square or skewed as directed by the designer. Show offset dimension on skewed ends.

Reinforcing is not normally shown in the plan view (except for beam dowels D, if required).

Anchor: #i1004977

Partial Elevation View

Cap dimensions, bar sizes, and spacing are as directed by engineer.

Partial Elevation View.  (click in image to see full-size image) Anchor: #i1000489grtop

Figure 4-8. Partial Elevation View.

Online users can click 4-8 to view this illustration in PDF.

Anchor: #i1004992

Section A-A Example

Dimensions, bar spacing, and bar sizes are as directed by the designing engineer, except when minimum values are shown.

Section A-A Example.  (click in image to see full-size image) Anchor: #i1000497grtop

Figure 4-9. Section A-A Example.

Online users can click 4-9 to view this illustration in PDF.

Previous page  Next page   Title page